Ver detalhes
MB PRO 2 COM 1802
Máquina novaVendedor verificado
Pedir preço
Diretamente ao vendedor
1 / 7
Dados técnicos
· ID 169912496Máquinas usadas
- Estado
- Máquina nova
- Localização
- 48683 Ahaus
Identifikation
FabricanteMB
ModeloPRO 2 COM 1802
Número do artigo1125-8459010
Technik
Quantidade1
Descrição
table diameter: 340 mm
table load: 160 horizontal kg.
table load: 100 vertikal kg.
swivelling range: 0 - 90.0 Grad
turning speeds: 0.6 - 6.0 U/min
bore: 60.0 mm
motor: 230 Volt
weight of the machine ca.: 56.0 kg
range L-W-H: 385 x 340 x 375 mm
Furnishing:
- The table can be adjusted at an angle of 0 to 90 degrees tilt and jam
- Start / stop via a location-independent foot switch.
- Direction of rotation can be selected right / left.
- Adjustable rotation time
- The turntable has a 60 mm hollow shaft
- The turntable has a diameter of
340 mm. The surface is chrome-plated for
Protection against welding spatter.
- The table speed is adjustable from 0.6 - 6 rpm.
- The control of the welding machine via
the turntable control is possible.
- The ground contact transmits 300 A / 100%.
- The turntable and the control are separate.
- HF protected.
- COM 1800 control with lap welding
- Operating instructions in German
Functions COM 1800 control:
- Right/left rotation
- Infinitely variable speed control
- Welding torch on/off
- Overlap welding adjustable
- Controller for rotation time (2-stroke / 4-stroke)
- Speed display
The data for this ad was created with ModulMWS - the software solution of LogoTech oHG.
table load: 160 horizontal kg.
table load: 100 vertikal kg.
swivelling range: 0 - 90.0 Grad
turning speeds: 0.6 - 6.0 U/min
bore: 60.0 mm
motor: 230 Volt
weight of the machine ca.: 56.0 kg
range L-W-H: 385 x 340 x 375 mm
Furnishing:
- The table can be adjusted at an angle of 0 to 90 degrees tilt and jam
- Start / stop via a location-independent foot switch.
- Direction of rotation can be selected right / left.
- Adjustable rotation time
- The turntable has a 60 mm hollow shaft
- The turntable has a diameter of
340 mm. The surface is chrome-plated for
Protection against welding spatter.
- The table speed is adjustable from 0.6 - 6 rpm.
- The control of the welding machine via
the turntable control is possible.
- The ground contact transmits 300 A / 100%.
- The turntable and the control are separate.
- HF protected.
- COM 1800 control with lap welding
- Operating instructions in German
Functions COM 1800 control:
- Right/left rotation
- Infinitely variable speed control
- Welding torch on/off
- Overlap welding adjustable
- Controller for rotation time (2-stroke / 4-stroke)
- Speed display
The data for this ad was created with ModulMWS - the software solution of LogoTech oHG.
Pedir informações sobre esta máquina
O seu pedido é enviado diretamente ao vendedor desta máquina.
